10008: Base Page

Draw a base device page. Base pages are pre-defined pages in the device firmware, such as the home page. These may differ in their appearance between device types.

Payload

Field	Name	Description	Type	Unit
3	Page ID	The page to draw. Possible values: 1: Home Page— The preset home page programmed into the device 5: Diagnostics Page— The preset diagnostics page programmed into the device	uint8
5	Status bar Enable	Show the status bar	bool
6	Redraw Type	Possible values: 0: Auto— Automatically choose the redraw type, based on page id. No page id provided will assume the same page id as last set. Same page id as last set will do a partial redraw, and leave the buffer intact. Changed page id will clear the buffer and do a full redraw. 1: PartialRedraw— Only redraw the parts of the screen changed in this message. Leaves the buffer intact. Will occasionally do a full redraw if the firmware thinks it is needed. 2: FullRedraw— Clear the screen buffer, and redraw the entire screen 3: BufferOnly— Do not redraw the screen, only update the buffer. Will clear the buffer if the page id has changed. Similar to Auto, but will not redraw the screen. Similar to ClearDontDraw, but only clears the buffer if the page id has changed. 4: FullRedrawWithoutClear— Redraw the entire screen, without clearing the buffer 5: ClearDontDraw— Clear the screen buffer (always), but don't redraw. Similar to BufferOnly, but always clears the buffer.	uint8

Pages

This is what the base pages actually look like.

1: Home page

RH2

Examples

Request the home page (page 1) to be drawn

📡 Real example from RH2 ESP32 Toit. on 2025-10-10This example is captured from an RH2 device as part of normal communications over I2C with the ESP32 co-processor, where Toit on the ESP32 make the request.

Request the diagnostics page (page 5) to be drawn

📡 Real example from RH2 ESP32 Toit. on 2026-08-07This example was generated using the generate tool, and tested against an RH2 device, sent from Toit.

Code

For convenience, the following constants can be used to reference this message type.